Frequent Issues
- My trackers go the wrong direction
- Make sure IMU_ROTATION in firmware is correct.
- Make sure your mounting orientation in the server is correct. (you might have to lie about them for certain setups)
- If it's only off by a few degrees, shift your trackers inwards or outwards a bit, then full reset.
- My avatar floats above the ground
- Increase your user real height in VRChat.
- My legs don't bend
- Make sure you have upper leg trackers above your knees and assigned as "upper leg" trackers as well as lower leg trackers below your knees assigned as "lower leg" trackers.
- Make sure your lower legs trackers are set as "lower leg" and are on your lower legs, not feet.
- Make sure VRChat is binding your feet to your feet trackers, not knee trackers.
- My feet go through the floor/my feet are sliding/tracking isn't precise enough, not 1:1/etc...
- If you are using 5 trackers, get a sixth tracker.
- Make sure your body proportions are configured properly: body proportions page
- My legs cross when sitting down
- Try mounting your upper leg trackers more inwards.
- Try mounting your upper leg trackers higher on your thighs or lower on your upper legs depending on your build.
- Calibrate with your legs straight and a normal hip width (24-32) in your body proportions.
- Use fast reset to correct leg crossing: assigning a keybind for resetting
- One my leg is higher than the other one
- Shift your upper leg trackers a bit.
- Try out other mountings for your upper leg trackers
- My elbows are flaring out outwards in VRChat
- Calibrate with your arms rotated more inwards in VRChat. Your elbows' rotations must match your avatars'.